[HAM] speaker connection on M-100

[Wayne]

Hi,

As Organtec said, the 2 12 inch speakers are driven in parallel by the  
main amp. The input for the reverb amp is taken from the VC terminal on  
one of the 12 inch speakers.

The output of the reverb amp goes to the reverb I and reverb II switches,  
then to the 8 inch speaker.

I sold my M-111 organ so I can't look to check wire colors, but the black  
wire is most likely ground, both the 12 inch and 8 inch speakers have one  
side of the VC grounded.

The green wire probably does not go to the TG, but rather to the reverb  
switches. You will need to trace out the wiring to the reverb switches and  
find the two correct wires, one to the reverb amp output and one to the 8  
inch speaker. Wiring from the main amp to the 12 inch speakers and from  
the 12 inch speaker to the reverb amp input should be pretty much obvious.

Of course, if the previous owner made more extensive changes than just  
removing the reverb amp and two speakers, then anything is possible as far  
as the wiring condition goes.

By the way, the two 12 inch speakers are not identical. One, with the  
larger magnet, is the "bass" speaker and the other is the "treble"  
speaker. No crossover is used.

Hope this is of some help.

Wayne


On Fri, 05 Jan 2007 07:49:17 -0800, Stainless Brown  
<stainlessbrown at sbcglobal.net> wrote:

> Something is amiss--- This is a M-111 (I always though the two digits  
> after the first one had to do with the cabinet/style/finish)
>  anyway- the 8" speaker has one lead which comes from the AO-29   
> (terminal is marked "BN" over a "T". The other speaker wire is blue and  
> goes up into the tone gereator.
>  From the same BN/T terminal is a black wire, which seems to be paired  
> with a green wire (comes from the tone generator), both of which have  
> been cut when the previous owner pulled the AO-44-  would these be the  
> signal inputs for the AO-44  (and would it watter which wire went to  
> which terminal
>  ..which leaves me at the speaker output from the AO-44 and where  
> exactly do I connect it?
>  Stan
>  Organtec <organtec at charter.net> wrote:
>   The reverb amp drives the 8" speaker. The main amp drives the 2 12" in
> parallel.