[HAM] M3 with bad starter motor?

[John Freund]

>   There is a small rectangle oil cup adjacient to the motor 
> with a fine thread to direct the oil to where it needs to be 
> lubricated. Be sure you have oiled this cup about only about 
> 2/3 full and the thread is not broken. It obviously is not 
> getting the oil where it needs it.

My understanding with the run/scanner cup is that if the pad is wet then
there is plenty of oil for the wicks.  Don't add to it, thus avoiding an
over-oiled scanner.  A wick-thread inspection is always a good idea,
however.

/John