[HAM] Ignorant soldering questions

[Bohachewsky, Andrew V.]

Is this an 860?

I have one where the fuse has been blown as well. The solution in that
case was a dual gang fuse holder which snaps onto the original (blown)
fuse but also has parallel snaps for a new unblown fuse with some
carboard insulating material (This was done by a previous owner/user).
Apparently these clip ons were common "back in the day". Check Radio
Shack.

Andy

Not honorable but trying to help anyway...



-----Original Message-----
From: hammond-bounces at zeni.net [mailto:hammond-bounces at zeni.net] On
Behalf Of Bruce Gordon
Sent: Tuesday, July 17, 2007 3:40 PM
To: Hammond List
Subject: [HAM] Ignorant soldering questions

Honorable Listpeople,
  I have a blown fuse in my solid state Leslie which I
want to replace.  Instead of a snap-in, it has two
wire leads attached to it, and then it disappears into
a circuit board