[HAM] Tone Generator

[Christoph P. Kukulies]

On Mon, Mar 12, 2007 at 03:35:26PM -0700, HUGH HINSKENS wrote:
> I meant using a resistor as a load just for the purpose of measurement so that you would get more consistent measurements in the event that the probe impedance was affecting the readings.
> 
> Paralleling a resistor at the TG terminal is an alternate method to bring down the signal as opposed to the more dangerous pickup adjustment.

I don't think that the probe would influence the measured TG level in any
significant way since I assume that the input resistance of Dennis' equipment
would be far higher (10KOhms to some 100KOhms).

At least this is so with a scope probe (10M).
--
Chris Christoph P. U. Kukulies kuku_at_kukulies.org