[HAM] connecting Leslie 25 w /amp to L100

[David Damroze]

On Mar 28, 2007, at 6:39 AM, Jeff Dairiki wrote:

> On Tue, 2007-03-27 at 19:14 -0800, David Damroze wrote:
>>   I picked up an M3 with a Leslie 25 from a church that needed the 
>> space.
>>   The M3 isn't working , so I'd like to connect the Leslie to my L100.
>>   Can I just use the connector kit in the M3 , or do I need something
>> else or in addition to the
>> hardware in the M3 ?
>
> The answer to that question would, of course, depend on what kit is in
> your donor M3.  But the hookup for an L-100 would normally be pretty
> much the same as for an M-3, so you're probably set.
  I've copied the connections from the M3 . I think I've got it as far 
as the speaker
wires are concerned.
  My main question is where to connect the blue and grey power wires.
  I've found the little panel on the L100 that the power lines run to.
  The Leslie manual says to solder them to the AC lugs . My concern
  is that the Leslie will be running even if the organ is off.

David D.
>
> Again, though, it's hard to say for sure without knowing a bit more
> about what you've got.
>
>
> --
> Subscription Options/Unsubscribe/Archives: http://www.zeni.net/hf/
> Hammond-Leslie FAQ: http://theatreorgans.com/hammond/faq/
> HammondWiki: http://www.dairiki.org/HammondWiki/
> hammond at zk3.dec.com archives: http://zk3.hammondforum.com/
>