[HAM] Homebrew A-100 kit

[Eric S.]

Hi,
Longtime lurker, haven't posted in a while.  I put together a functional 
interface between my A-100 and Leslie 44W which works well. I don't have 
an MEE switch and would like to play the organ without the internal 
speakers. 

If connecting the Leslie to the A-100 power amp, I believe I can use the 
Leslie's load resistor set at 8ohms, to protect the A-100 power amp and 
disconnect the A-100 speaker.  Correct?  Alternatively,  I can put a 
load resistor in  the console.  If so, would 10W 8 ohm be appropriate?

If I prefer to run the Leslie off the AO-28 (one G terminal and ground), 
can I just pull the tubes out of the A-100 power and reverb amps?

Thanks
Eric