[HAM] Homebrew A-100 kit

[John Freund]

If you don't want to hear the A100 speakers, don't want to hear reverb in
the Leslie and don't want to switch between the speakers and the Leslie,
just connect the Leslie via GG terminals, set the Leslie load to open and
disconnect (or even better, for quick reversibility, put a switch on) the AC
to the power/reverb amps.  

Done.

/John

> Hi,
> Longtime lurker, haven't posted in a while.  I put together a functional
> interface between my A-100 and Leslie 44W which works well. I don't have
> an MEE switch and would like to play the organ without the internal
> speakers.
> 
> If connecting the Leslie to the A-100 power amp, I believe I can use the
> Leslie's load resistor set at 8ohms, to protect the A-100 power amp and
> disconnect the A-100 speaker.  Correct?  Alternatively,  I can put a
> load resistor in  the console.  If so, would 10W 8 ohm be appropriate?
> 
> If I prefer to run the Leslie off the AO-28 (one G terminal and ground),
> can I just pull the tubes out of the A-100 power and reverb amps?
> 
> Thanks
> Eric