[HAM] Homebrew A-100 kit

[Bohachewsky, Andrew V.]

Use G and ground. Just pull the rectifier tube out of the A100 power amp
(5U4? It's the single big one.)

That being said... A100 internal speakers PLUS a Leslie sounds really
nice.

Andy

-----Original Message-----
From: hammond-bounces at zeni.net [mailto:hammond-bounces at zeni.net] On
Behalf Of Eric S.
Sent: Monday, October 01, 2007 12:03 PM
To: hammond at zeni.net
Subject: [HAM] Homebrew A-100 kit

Hi,
Longtime lurker, haven't posted in a while.  I put together a functional

interface between my A-100 and Leslie 44W which works well. I don't have

an MEE switch and would like to play the organ without the internal 
speakers. 

If connecting the Leslie to the A-100 power amp, I believe I can use the

Leslie's load resistor set at 8ohms, to protect the A-100 power amp and 
disconnect the A-100 speaker.  Correct?  Alternatively,  I can put a 
load resistor in  the console.  If so, would 10W 8 ohm be appropriate?

If I prefer to run the Leslie off the AO-28 (one G terminal and ground),

can I just pull the tubes out of the A-100 power and reverb amps?

Thanks
Eric
--
Subscription Options/Unsubscribe/Archives: http://www.zeni.net/hf/
Hammond-Leslie FAQ: http://theatreorgans.com/hammond/faq/
HammondWiki: http://www.dairiki.org/HammondWiki/
hammond at zk3.dec.com archives: http://zk3.hammondforum.com/