TRIUMPH TR6
PLATE GV
SPECIAL SERVICE TOOLS, SECTION II
GEARBOX AND OVERDRIVE
V2-98
SPECIAL SERVICE TOOLS, SECTION II--GEARBOX AND OVERDRIVE
Note:
Special Service tools for Triumph cars were
manufactured and distributed by the Messrs. V.L.
Churchill and Company now located in Daventry,
Northants. Although most of these tools are now
unavailable, we are listing them here with illustrations
for your information. We have also produced special
runs of a few of these tools, and we will produce more
if demand exists.
CHURCHILL GEARBOX SERVICE TOOLS
CLRG421
Wrench,
for holding rear drive flange
1
CLS316
Wrench,
for holding rear drive flange (Alternative to
1
CLRG421.)
CLS4235A-2
Adaptor,
input shaft remover (Used with CL4235A, Slide
1
Hammer.)
CLS4221A-15A
Adaptor Set,
input shaft bearing remover/replacer,
1
mainshaft center bearing remover (Used with CL47,
Multi-Purpose Hand Press.)
Driver,
for installation of closed-cage countershaft
1
needle bearings
CLS69B
Remover,
mainshaft circlip
1
Replacer,
mainshaft circlip
1
CLS314
Bearing Driver/Abutment Plate Set,
replacing main
1
shaft rear bearing
CHURCHILL A-TYPE OVERDRIVE SERVICE TOOLS
CLL188A
PRESSURE TEST EQUIPMENT,
including gauge, hose,
1
and adaptor
CLL188-4
Hose,
pressure test
1
CLL187
Adaptor Set,
tailshaft bearing remover/replacer (Used
1
with CL47, Multi-Purpose Hand Press.)
CLL182
Remover,
accumulator piston housing
1
Remover,
pump barrel
1
CLL183-1
Adaptor
(Used with CLL183A, Pump Barrel Remover.)
1
CLL185A
Dummy Drive Shaft
1
CLL178
Jig,
freewheel assembly
1
CLL184
Replacer,
oil pump body
1
CHURCHILL J-TYPE OVERDRIVE SERVICE TOOLS
CLL188A
PRESSURE TEST EQUIPMENT,
including gauge, hose,
1
and adaptor
CLL188-4
Hose,
pressure test
1
CLL188A-2
Adaptor,
pressure take-off
1
CLL402
Adaptor,
pressure, spline release
1
CLL354A
Adaptor,
spanner, oil pump plug
1
CLL401A
Remover/Replacer Tool,
relieve valve body and
1
dashpot sleeve
CLL178A
Jig,
freewheel assembly
1
Plate No.
Part No.
Description
No. Off
Plate No.
Part No.
Description
No. Off
